All Electric RC
Home
RC Aircraft
RC Helicopters
RC Cars
Brushless Motors
Speed Controllers & UBEC
Battery Packs
Chargers Balancers
Radio Equipment
RC Accessories
IC Engines
Aircraft Propellers
Covering & Glues
Search

Shopping Cart
ItemQtyPrice

Sub Total: £0.00
Delivery: £0.00
Total: £0.00




Categories
  Home > RC Aircraft > PARKZONE >

ParkZone Ultra Micro J-3 Cub BNF

ParkZone Ultra Micro J-3 Cub BNF


  • Wingspan      460 mm (18.2")
  • Length     314 mm (12.4")
  • Weight     24 g (.85 oz)
  • Receiver:     PKZ 3 channel 2.4GHz DSM 2 RX/ESC unit
  • Battery     3.7V 120mAh LiPO
  • Charger     DC single cell fast charger

    * Three-channel control (rudder/elevator/throttle) that’s perfect for intermediate pilots
    * Difficult to damage and easy to repair thanks to highly durable EPS foam
    * Lightweight at only 24 grams
    * Lots of power through lightweight 3.7V Li-Po battery
    * No worries about interference because of DSM2 radio architecture
    * Quick and safe battery charging courtesy of DC Li-Po charger

Parkzone continue to expand their range of scale indoor electric flyers with this delightful ready to fly Piper J3 Cub.

The all foam ready to fly one-piece model features an under cambered wing section designed to allow the model to be flown slowly and an upper wing surface with moulded in wing ribs and doped fabric effect finish for a more scale like appearance.

The engine cowling is complete with dummy Lycoming engine cylinders whilst the lower fuselage has a convenient moulded battery placement “pocket”. The model is finished in a scale Piper yellow colour scheme with black accents, registration numbers and of course the Piper Teddy Bear logo on the tail-fin.

On board the 2.4 GHz fully proportional three channel electronics controlling throttle, elevator and rudder are pre-installed with sprung carbon pushrods to the rudder and elevator. The steerable tail wheel and scale looking sprung wire landing gear comes complete with lightweight foam Cub “doughnut” wheels, enabling the model to take off and land on smooth surfaces.

This one box purchase comes complete with everything included, a 2.4Ghz transmitter, 1S 3.7volt 120 mAh Li-Po battery and Li-Po balancing charger powered by 4 AA dry batteries. With no further building or additional purchases needed this super little model can be in the air in no time at all.

Designed primarily for indoor flight and weighing in at a mere 25 grams this super model is sure to delight indoor pilots with its scale like flying characteristics and good looks and there is no doubt that this great little model could also be flown outdoors in very calm conditions when there is little or no wind.

This is the BNF Version require Transmitter




Our Price: £69.99




« Back






Blade mQX £89.99

New Updated 2012 Edition
With 40Amp ESC


Events

You will find us at the following shows:-


Special Offers
Power-Tech C6 Charger DC





2MTR EASYCOTE BRIGHT RED (22)2MTR EASYCOTE BRIGHT RED (22)
£8.95



Site Map | Terms & Conditions
All Electric RC - Your Local Electric RC Flight Specialist